Jack Ryan
Tue. 26 Mar.13,
17:54
|
| Volume Coil info in DICOM Header? |
| |
Hello, I need to find out what type of head coil was used for several studies that our lab has run in the past. Essentially I just need to know the number of channels. I've used the dicomread and dicominfo commands in Matlab to no avail, but I've had some luck using syngo (from Siemens) on some of our later studies. I want to check for my sanity that this is possible to do, but if it is not, I'm curious if there are other techniques for finding out this information, rather than just eyeballing the quality of the the scan images. Thanks -Jack
|
Forum Overview
Category:
